1.0 OBJECTIVE 1.1 To describe a procedure for the preventive maintenance of autoclave. 2.0 SCOPE 2.1 This procedure applies to the Engineering department. 3.0 RESPONSIBILITY 3.1 Engineering 4.0 ACCOUNTABILITY 4.1 Plant Head 5.0 REFERENCE 5.1 In-house. 6.0 PROCEDURE 6.1 Procedure for mechanical work: 6.1.1 ...

1.0 OBJECTIVE 1.1 To describe a procedure for the calibration of pressure gauge. 2.0 SCOPE 2.1 This procedure applies to the Engineering department. 3.0 RESPONSIBILITY 3.1 Engineering 4.0 ACCOUNTABILITY 4.1 Plant head 5.0 REFERENCE 5.1 In-house. 6.0 PROCEDURE 6.1 Close the line in which Pressure Gauge ...

1.0 OBJECTIVE: To lay down a procedure for Operation of Boiler. 2.0 SCOPE: This SOP is applicable for Operation of Boiler at …………. 3.0 RESPONSIBILITY: Officer / Executive – Engineering 4.0 ACCOUNTABILITY: Head – Engineering 5.0 DEFINITION: Not Applicable 6.0 PROCEDURE: 6.1 PRE STARTUP CHECKS: 6.1.1 ...

O Preventive Maintenance of Hot Plate O Preventive Maintenance of Autoclave O Preventive Maintenance of Humidity Chamber O Preventive Maintenance of Eye-Washer O Preventive Maintenance of Water Bath O Preventive Maintenance of Hot Air Oven O Preventive Maintenance of Muffle Furnace O Preventive Maintenance ...

Objective: To establish a standard maintenance procedure of Hoist Scope: This SOP is applicable for Hoist of (Company Name). Responsibility 1. Operator shall be responsible to follow the procedure strictly. 2. Supervisor shall be responsible to ensure that the SOP is followed properly. Accountability: ...

Objective To establish a standard procedure for operation of DOP tester. Scope This SOP is applicable for the operation of Aerosol Photometer (Model: TDA-2GN) and the aerosol generator (Model: TDA-5B) of (Company Name). Responsibility =>> Maintenance Engineer shall be responsible to follow the procedure ...

Objective: To establish a standard preventive maintenance procedure for Electrical Lift. Scope: This SOP is applicable for the Electrical Lifts installed at (Company Name). Responsibility 1 Maintenance Engineer shall be responsible to follow the procedure strictly. 2 Supervisor shall be responsible ...

Objective: To establish a standard operating procedure for challenge test of BAS system. Scope: This SOP is applicable for the Building Automation Systems of OSD and MDI Units of (Company Name). Responsibility 1 Operator shall be Responsible to follow the procedure strictly. 2 Supervisor shall be responsible ...

1.0 OBJECTIVE To establish a standard operating procedure for startup and stop of Purified Water System. 2.0 SCOPE This SOP is applicable for the Building Automation Systems of OSD Units of (Company Name). 3.0 RESPONSIBILITY 3.1 Operator shall be Responsible to follow the procedure strictly. 3.2 Supervisor ...

1.0 OBJECTIVE To establish a standard preventive maintenance procedure for the Co-mill. 2.0 SCOPE This SOP is applicable for the preventive maintenance of Co-mill installed at the Granulation area of (Company Name). 3.0 RESPONSIBILITY 3.1 Maintenance Engineer shall be responsible to follow the procedure ...